Primary tabs
Membrane ALKA Clean RXSOL ORG-10
SKU::RXSOL-33-3320-025
Membrane ALKA Clean RXSOL ORG-10 is a high pH formultion that has been designed specifically to remove organics, silt and other particulate deposits from all polyamide, polysulfone and thin film composite membrane surfaces.
Membrane ALKA Clean RXSOL ORG-10 is a powdered buffered alkaline detergent developed, Especially for cleaning alkaline tolerant reverse osmosis and ultrafiltration membranes.
Inspect cleaning tank, hoses and cartridge filter. Install new filter elements.
Fill cleaning tank with RO solution then, Slowly add 25 grammes of ORG 10 for each litre of cleaning tank capacity. Thoroughly mix cleaning solution by using a mixer or by circulating it through the cleaning pump. The solution may be heated to improve cleaning effectiveness.
Do not exceed the membrane manufacturer’s temperature limits.
Circulate the solution through the membrane bank in the feed direction for one hour at the flow rate recommended by the membrane or system manufacturer. If the manufacturer’s recommendations are not available, the following guidelines may be used.
Maintains production capacity
Special formula maintains membrane flux rate
Chelates and buffered alkalinity effectively remove fouling agents from alkaline
Tolerant RO and UF membranes
BENEFIT :::
Dissolves freely to reduce labor and cleaning time, Easy to add balance formulation eliminates need for adding separate additives or boosters, Rinse quickly and completely to reduce cleaning time
ITS ADVANCE FORMULATION Makes Economical use cost and recommended use dilution, Chlorine free formulation helps assure compatibility with membrane to Extent membrane life.
Spiral wound membrane
|
Membrane diameter |
Flow rate per tube (parallel flow) |
| 4 | 23 (6) |
| 6 | 53 (14) |
| 8 | 91 (24) |
| 10 | 114 (38) |
| 12 | 204 (54) |
Hollow fibre membrane
|
Membrane diameter |
Flow rate per element (parallel flow) |
| 4 | 19 (6) |
| 8 | 57 (24) |
| 10 | 76 (38) |
TO USE
For normal CIP cleaning or soak cleaning RO and UF system completely , Pre dissolve in warm water before adding to system. Typically used Concentration is 0.7 to 1.5 % or 9-20 ounces of RXSOL ORG 10 per each 10 Gallon (67-150 grams/10 l) f water. Circulate throughout the system for 20 Minutes at a temperature of 120-160 degree F (49 – 71 degree C)
Note:
Observe the recommendation of the manufacturer of the membrane for Maximum temperature.
In cases of heavy fouling, the first return flow (up to 15% of the cleaning tank volume) should be diverted to drain to prevent redeposition of removed solids.
In multi-pass systems, best results will be achieved if each pass is cleaned separately.
The solution should be discarded if it becomes turbid or discoloured by removed material.
A fresh solution should then be prepared before cleaning additional passes.
Rinse with permeate before returning the system to service.
Features of Membrane ALKA Clean RXSOL ORG-10 for effective RO Membrane Cleaning
- Suitable for use in Reverse Osmosis (RO) and NanoFiltration (NF) membranes
- Removes most organic and inorganic deposits
- Cost effective powdered product
- Compatible with all polyamide membranes
- Removes aluminium silicate
- Excellent for alkaline prewash
This advanced, high s trength powder has the following features:
- pH adjusted to 10+ 0.5
- Highly effective at ambient temperatures
- Contains no surfactants and is quickly rinsed away
- Contains detergent builders, chelating agents and pH buffer
RXSOL ORG-10 is suitable for use with all polyamide, polysulfone and thin film, composite membranes. It can be used at temperatures from 15°C (60°F) up to the maximum recommended by the membrane manufacturer.
The standard dilution ratio is 25 grammes of ORG 10 per litre of water.
PROPERTIES
Form ………………..........Powder Alkalinity
Color……………………... White
Active as Na2O……………… 16.2%
Foam …………...……….. High
Total as Na2O ………… 19.8 %
PH of 1% solution ……. 10 to 12
BULK DENSITY - 0.95 -
FREEZING POINT: NOT APPLICABLE
REVERSE OSMOSIS MEMBRANE CLEANER ALKALINE POWDER. Alkaline Powder RO CLEANER IS ALSO HIGHLY EFFECTIVE AGAINST MOST FORMS OF COLLOIDAL FOULING, BIOFILM AND ORGANIC FOULANTS TYPICALLY FOUND IN REVERSE OSMOSIS AND NANO-FILTRATION MEMBRANES SYSTEMS.
Membrane ALKA Clean RXSOL ORG -10 Powder MC11 is alkaline pH products to clean and remove organics, silt and other particulate deposits from membrane polyamide, polysulfone and thin film composite membrane surfaces.
Reverse Osmosis RO Membrane ALKALINE Cleaner RXSOL ORG -10 is Powder formulatory product. We are manufacturer, exporter and supplier in Mumbai - MIDC Taloja, Koparkhairna, Mahape, PAWANE Turbha, Nashik Pune, Gandhidham GIDC, Kolkata, Haldia, Paradip, Patna, Munger, Ranchi, Tata, Chennai - Ennore, Visakhapatnam, Manglore, Goa, Fujairah, Abudhabi, Ajman, Sharjah, Diera, UAE - Middle East, Barka, Muscat, Oman, Nairobi Kenya Africa
Membrane ALKA Clean RXSOL ORG-10 is a powder form multicomponent, high pH buffered cleaner formulated to remove biological fouling.
RXSOL ORG 10 is also suitable for meat and poultry plant as a cleaner for reverse Osmosis and Ultra filtration membranes. RXSOL ORG 10 must be used in a manner which prevents direct or indirect contamination of edible.
